Hyundai Kona: Air Conditioning System / A/C Pressure Transducer Description and operation

The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed. Engine ECU stops the operation of the compressor when the temperature of refrigerant line is very high or very low irregularly to optimize air conditioning system.

Receiver-Drier Repair procedures

Replacement 1. Remove the condenser. 2. Remove the cap (A) on the bottom of the condenser with a L wrench. ...

A/C Pressure Transducer Repair procedures

Inspection 1. Measure the pressure of high pressure line by measuring voltage output between terminal "1" and "2". ...

Other information:

Hyundai Kona (OS) 2018-2024 Service Manual: Blower Resistor (Manual) Repair procedures
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) ...

Hyundai Kona (OS) 2018-2024 Owners Manual: Limitations of the system
The Forward Collision avoidance assist (FCA) system system is designed to monitor the vehicle ahead or a pedestrian in the roadway through radar signals and camera recognition to warn the driver that a collision is imminent, and if necessary, apply emergency braking. In certain situations, the ra ...