Hyundai Kona: Lighting System / Door Mirror Lamp Repair procedures

Remove
1.
Disconnect (-) battery terminal.
2.
Remove door mirror assembly.
(Refer to Body - "Mirror")
3.
Remove mirror (A) to the direction as shown in the picture using (-) screw driver.
  
Protect mirror from removing tool with cloth (B) wrapped.
Be careful not to damage mirror and mirror housing during removing process.
Apply force around the center of mirror because to apply force the end of mirror will break it.

4.
Disconnect the connector (A) and then remove the door mirror lamp (B).

Installation
1.
Install the door mirror lamp.
2.
Connect the lamp connector and then install the mirror.
3.
Install the mirror assembly to the vehicle.
4.
Connect the negative (-) battery terminal.
Turn Signal Lamp Repair procedures
Removal Front turn signal lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the Daytime Running Ligh ...

Room Lamp Repair procedures
Removal [Room Lamp] 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, Separate t ...

Other information:

Hyundai Kona (OS) 2018-2024 Service Manual: Cylinder Head Repair procedures
Removal Engine removal is not required for this procedure.    • Use fender covers to avoid damaging painted surfaces. • To avoid dama ...

Hyundai Kona (OS) 2018-2024 Owners Manual: Engine compartment panel fuse replacement
1. Turn the vehicle off. 2. Turn all other switches OFF. 3. Remove the fuse panel cover by pressing the tab and pulling up. 4. Check the removed fuse; replace it if it is blown. To remove or insert the fuse, use the fuse puller in the engine compartment fuse panel. 5. Push in a new fuse of the sam ...

© 2018-2024 www.hkona.com