Hyundai Kona: Auto Head Lamp Leveling Device / Head Lamp Leveling Switch Repair procedures
| Inspection |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
|
| 3. |
Remove the lower crash pad switch assembly (A) after disengaging
the mounting clip.
|
Components and components location
Component Location
1. Head lamp leveling unit
2. Head lamp leveling actuator
(Built - in Head lamp)
...
Auto Head Lamp Leveling Unit Schematic diagrams
Circuit Diagram
...
Other information:
Hyundai Kona (OS) 2018-2024 Owners Manual: Checking the tire inflation pressure
1. After driving approximately 7~10 km (4~6 miles or about 10 min), stop at a
safety location.
2. Connect the connection hose (9) of the compressor directly to the tire valve.
3. Plug the compressor power cord into the vehicle power outlet.
4. Adjust the tire inflation pressure to the recomended t ...
Hyundai Kona (OS) 2018-2024 Owners Manual: Windshield wipers
Operates as follows when the ignition switch is turned ON.
/MIST : For a single wiping cycle,
move the lever down ( ) or up (MIST) and release it. The wipers will operate continuously
if the lever is held in this position.
O/OFF : Wiper is not in operation
---/INT : Wiper operates intermittently a ...
