Hyundai Kona: Engine Control System / Accelerator Position Sensor (APS) Description and operation

Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line. The second sensor monitors the first sensor and its output voltage is half of the first one. If the ratio of the sensor 1 and 2 is out of the range (approximately 1/2), the diagnostic system judges that it is abnormal.

Rail Pressure Sensor (RPS) Repair procedures

Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...

Accelerator Position Sensor (APS) Specifications

Specification Accelerator Position Output Voltage (V) APS1 APS2 C.T 0.7 - 0.8 0.325 - 0.4 ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Front Stabilizer Bar Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from the front hub. Tightening torque : 107.9 - 12 ...

Hyundai Kona (OS) 2018-2026 Service Manual: Cowl Side Trim Repair procedures
Replacement    • Put on gloves to prevent hand injuries.    • Wh ...