Ford Fusion: Wipers and Washers / Autowipers (IF EQUIPPED)

Note: Fully defrost the windshield before you switch the windshield wipers on.

Note: Make sure that you switch the windshield wipers off before entering a car wash.

Note: If streaks or smears appear on the windshield, clean the windshield and the wiper blades. If that does not resolve the issue, install new wiper blades.

Note: If you switch autolamps and autowipers on, the headlamps turn on when the windshield wipers continuously operate.

Wet or winter driving conditions with ice, snow or salty road mist can cause inconsistent and unexpected wiping or smearing.

Ford Fusion. Autowipers (IF EQUIPPED)

  1. High sensitivity.
  2. Autowipers on.
  3. Low sensitivity.

Move the wiper lever upward to the first position to switch the autowipers on.

Use the rotary control to adjust the sensitivity of the autowipers. When you select low sensitivity, the wipers operate when the sensor detects a large amount of water on the windshield. When you select high sensitivity, the wipers operate when the sensor detects a small amount of water on the windshield.

Keep the outside of the windshield clean. The rain sensor is very sensitive and the wipers may operate if dirt, mist or insects hit the windshield.

In these conditions, you can do the following:

Autowipers Settings

Autowipers defaults to on and remains on until you switch it off in the information display. When you switch off autowipers, the wipers operate in intermittent mode.

Windshield Wipers
Push the lever up or down to operate the windshield wiper. Single wipe. Intermittent wipe. Normal wipe. High speed wipe. Note: Fully defrost the windshield before you switch the windshield w ...

Windshield Washers
Pull the lever toward you to operate the windshield washers. When you release the lever, the wipers operate for a short time. When activated, a courtesy wipe occurs a short time after the wipers ...

Other information:

Hyundai Kona (OS) 2018-2021 Owners Manual: Selecting a Child Restraint System (CRS)
When selecting a Child Restraint System for your child, always: Make sure the Child Restraint System has a label certifying that it meets applicable Safety Standards of your country. A Child Restraint System may only be installed if it was approved in accordance with the requirements of ECE-R ...

Hyundai Kona (OS) 2018-2021 Service Manual: Engine Coolant Temperature Sensor (ECTS) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Remove the ECTS. (Refer to "Removal") 3. After immersing the thermistor of the sensor into engine coolant, measure resistance between the EC ...

© 2018-2021 www.hkona.com