Ford Fusion: Maintenance / Changing a Bulb

WARNING: Switch the lamps and the ignition off. Failure to follow this warning could result in serious personal injury.

WARNING: Bulbs can become hot. Let the bulb cool down before removing it. Failure to do so could result in personal injury.

Use the correct specification bulb.

Install in the reverse order unless otherwise stated.

Headlamp

Ford Fusion. Changing a Bulb

  1. Headlamp high beam.
  2. Headlamp low beam.

Note: LED headlamps are not serviceable. Have your vehicle checked as soon as possible.

Headlamp Low Beam

  1. Carefully remove the cover.
  2. Disconnect the electrical connector.
  3. Turn the bulb holder counterclockwise and remove it.

Note: Do not touch the bulb glass.

Note: You cannot separate the bulb from the bulb holder.

Headlamp High Beam

  1. Carefully remove the cover.
  2. Disconnect the electrical connector.
  3. Turn the bulb holder counterclockwise and remove it.

Note: Do not touch the bulb glass.

Note: You cannot separate the bulb from the bulb holder.

Front Halogen Fog Lamp

Ford Fusion. Changing a Bulb

Note: You cannot separate the fog lamp bulb from the bulb holder.

Note: Use caution when removing fog lamp facia cover from breaking or scratching.

  1. Remove the fog lamp cover, using a flat screwdriver.
  2. Remove the three fasteners using a screwdriver.
  3. Remove the lamp.

    Ford Fusion. Changing a Bulb

  4. Disconnect the electrical connector.
  5. Turn the bulb holder counterclockwise and remove it.
  6. Install the new bulb in reverse order.

LED Lamps

LED lamps are not serviceable. Have your vehicle checked as soon as possible.

The following lamps can be LED:

Reversing Lamp

1. Carefully remove the plastic trim clips holding the interior cover.

Ford Fusion. Changing a Bulb

2. Turn the bulb holder counterclockwise and remove it.

Ford Fusion. Changing a Bulb

  1. Press the bulb in and turn the bulb counterclockwise to remove it.

License Plate Lamp

Ford Fusion. Changing a Bulb

  1. Use a suitable tool, for example a screwdriver, to carefully remove the lamp.
  2. Remove the lamp.
  3. Turn the bulb holder counterclockwise and remove it.
  4. Remove the bulb by pulling it straight out.
Removing a Headlamp
Note: To remove push pins, use a flat-bladed screwdriver to pull up the center release pin. Make sure the headlamp control is in the off position and open the hood. Remove the six push pins se ...

Changing the Engine Air Filter
WARNING: To reduce the risk of vehicle damage and personal burn injuries, do not start your engine with the air cleaner removed and do not remove it while the engine is running. When changing the ...

Other information:

Ford Fusion 2013–2020 Owners Manual: The Better Business Bureau (BBB) Auto Line Program (U.S. Only)
Your satisfaction is important to Ford Motor Company and to your dealer. If a warranty concern has not been resolved using the three-step procedure outlined earlier in this chapter in the Getting the Services you need section, you may be eligible to participate in the BBB AUTO LINE program. T ...

Hyundai Kona (OS) 2018-2021 Owners Manual: Disc brakes wear indicator
When your brake pads are worn and new pads are required, you will hear a high pitched warning sound from your front or rear brakes. You may hear this sound come and go or it may occur whenever you depress the brake pedal. Note that some driving conditions or climates may cause a brake squeal when ...

© 2018-2021 www.hkona.com