Ford Fusion: Appendices / Electromagnetic Compatibility

Ford Fusion 2013–2020 Owners Manual / Appendices / Electromagnetic Compatibility

WARNING: Do not place objects or mount equipment on or near the airbag cover, on the side of the seatbacks (of the front seats), or in front seat areas that may come into contact with a deploying airbag. Failure to follow these instructions may increase the risk of personal injury in the event of a crash.

WARNING: Do not fasten antenna cables to original vehicle wiring, fuel pipes and brake pipes.

WARNING: Keep antenna and power cables at least 4 in (10 cm) from any electronic modules and airbags. Note:We test and certify your vehicle to meet electromagnetic compatibility legislation (UNECE Regulation 10 or other applicable local requirements). It is your responsibility to make sure that any equipment an authorized dealer installs on your vehicle complies with applicable local legislation and other requirements.

Note: Any radio frequency transmitter equipment in your vehicle (such as cellular telephones and amateur radio transmitters) must keep to the parameters in the following table. We do not provide special provisions or conditions for installations or use.

Car

Ford Fusion. Electromagnetic Compatibility

Van

Ford Fusion. Electromagnetic Compatibility

Truck

Ford Fusion. Electromagnetic Compatibility

Ford Fusion. Electromagnetic Compatibility

Note: After the installation of radio frequency transmitters, check for disturbances from and to all electrical equipment in your vehicle, both in the standby and transmit modes.

Check all electrical equipment:

Check that electromagnetic fields generated inside your vehicle cabin by the transmitter installed do not exceed applicable human exposure requirements.

Appendices
...

End User License Agreement
VEHICLE SOFTWARE END USER LICENSE AGREEMENT (EULA) You (“You” or “Your” as applicable) have acquired a vehicle having several devices, including SYNC ® and various control modules, ( ...

Other information:

Hyundai Kona (OS) 2018-2021 Service Manual: Purge Control Solenoid Valve (PCSV) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV terminals 1 and 2. 4. Check that the resistance is within the sp ...

Ford Fusion 2013–2020 Owners Manual: General Information
Condensation in the Exterior Front Lamps and Rear Lamps Exterior front lamps and rear lamps have vents to accommodate normal changes in air pressure. Condensation can be a natural by-product of this design. When moist air enters the lamp assembly through the vents, there is a possibility that c ...

© 2018-2021 www.hkona.com