Hyundai Kona: Warning and indicator lights / Electronic Brake Force Distribution (EBD) System Warning Light
.png)
These two warning lights illuminate at the same time while driving:
• When the ABS and regular brake system may not work normally.
In this case, we recommend that you have the vehicle inspected by an authorized HYUNDAI dealer.
WARNING
Electronic Brake Force Distribution (EBD) System Warning Light
When both ABS and Parking Brake & Brake Fluid Warning Lights are on, the brake system will not work normally and you may experience an unexpected and dangerous situation during sudden braking.
In this case, avoid high speed driving and abrupt braking.
We recommend you have the vehicle inspected by an authorized HYUNDAI dealer as soon as possible.
Information - Electronic Brake Force Distribution (EBD) System Warning Light
When the ABS Warning Light is on or both ABS and Parking Brake & Brake Fluid Warning Lights are on, the speedometer, odometer, or tripmeter may not work. Also, the EPS Warning Light may illuminate and the steering effort may increase or decrease.
In this case, we recommend you have the vehicle inspected by an authorized HYUNDAI dealer as soon as possible.
Anti-lock Brake System (ABS) Warning Light
This warning light illuminates:
When you set the ignition switch or the Engine Start/Stop button to the
ON position. - It illuminates for approximately 3 seconds and then goes off.
When there is ...
Electric Power Steering (EPS) Warning Light
This warning light illuminates:
When you set the ignition switch or the Engine Start/Stop button to the
ON position. - It illuminates for approximately 3 seconds and then goes off.
When there is ...
Other information:
Hyundai Kona (OS) 2018-2026 Service Manual: Rear Glass Defogger Printed Heater Repair procedures
Inspection
•
Wrap tin foil around the end of the voltmeter test lead
to prevent damaging the heater line. Apply finger pressure
on the tin foil, mo ...
Hyundai Kona (OS) 2018-2026 Service Manual: Seat Heater Switch Repair procedures
Removal
[Front Seat]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console assembly.
(Refer to Body - "Floor Console Assembly")
Installati ...
