Hyundai Kona: ISG (Idle Stop and Go) system / ISG system malfunction

The ISG system may not operate:

When there is a malfunction with the ISG sensors or the ISG system.

The followings occur, when there is a malfunction with the ISG system:

Information

WARNING

When the engine is in auto stop mode, the engine may restart. Before leaving the vehicle or checking the engine compartment, stop the engine by placing the ignition switch to the LOCK/OFF position or removing the ignition key.

To deactivate the ISG system
Press the ISG OFF button to deactivate the ISG system. Then, the ISG OFF button indicator illuminates, and the message "Auto Stop System Off" appears on the LCD display. Press the ISG OFF butto ...

The battery sensor deactivation
The battery sensor is deactivated, when the battery is disconnected from the negative pole for maintenance purpose. In this case, the ISG system is limitedly operated due to the battery sensor deac ...

Other information:

Hyundai Kona (OS) 2018-2025 Owners Manual: High Beam Assist (HBA) system
Operating condition 1.Place the light switch in the AUTO position. 2.Turn on the high beam by pushing the lever away from you. 3. The High Beam Assist (HBA) () indicator will illuminate. 4.The High Beam Assist (HBA) will turn on when vehicle speed is above 45km/h (25mph). 1) If the light switch i ...

Hyundai Kona (OS) 2018-2025 Service Manual: DCT Control Module (TCM) Repair procedures
Inspection Transmission Control Module (TCM) Inspection Procedure 1. Inspecting TCM ground circuit: Measure the resistance between the TCM and chiassis ground. (Check the terminal connected to the chassis ground while using the bac ...

© 2018-2025 www.hkona.com