Ford Fusion: Roadside Emergencies / Jump Starting the Vehicle

WARNING: Batteries normally produce explosive gases which can cause personal injury. Therefore, do not allow flames, sparks or lighted substances to come near the battery. When working near the battery, always shield your face and protect your eyes. Always provide correct ventilation.

WARNING: Keep batteries out of reach of children. Batteries contain sulfuric acid. Avoid contact with skin, eyes or clothing. Shield your eyes when working near the battery to protect against possible splashing of acid solution. In case of acid contact with skin or eyes, flush immediately with water for a minimum of 15 minutes and get prompt medical attention. If acid is swallowed, call a physician immediately.

WARNING: Use only adequately sized cables with insulated clamps.

Preparing Your Vehicle

Do not attempt to push-start your automatic transmission vehicle.

Note: Attempting to push-start a vehicle with an automatic transmission may cause transmission damage.

Note: Use only a 12-volt supply to start your vehicle.

Note: Do not disconnect the battery of the disabled vehicle as this could damage the vehicle electrical system.

Park the booster vehicle close to the hood of the disabled vehicle, making sure the two vehicles do not touch.

Connecting the Jumper Cables

WARNING: Do not connect the end of the second cable to the negative (-) terminal of the battery to be jumped. A spark may cause an explosion of the gases that surround the battery.

WARNING: Do not use fuel lines, engine valve covers, windshield wiper arms, the intake manifold, or hood latch as ground points.

Note: Do not attach the end of the positive cable to the studs or L-shaped eyelet located above the positive (+) terminal of your vehicle’s battery. High current may flow through and cause damage to the fuses.

Note:To avoid reverse polarity connections, make sure that you correctly identify the positive (+) and negative (-) terminals on both the disabled and booster vehicles before connecting the cables.

Note: Remove the red cap from the positive prong (B) on your vehicle before connecting the cables.

Ford Fusion. Jump Starting the Vehicle

  1. Negative prong (–).
  2. Positive prong (+).

Ford Fusion. Jump Starting the Vehicle

Note: In the illustration, the bottom vehicle represents the booster vehicle.

  1. Connect the positive (+) jumper cable to the positive (+) terminal of the discharged battery.
  2. Connect the other end of the positive (+) cable to the positive (+) terminal of the booster vehicle battery.
  3. Connect the negative (-) cable to the negative (-) terminal of the booster vehicle battery.
  4. Make the final connection of the negative (-) cable to an exposed metal part of the stalled vehicle's engine, away from the battery and the fuel injection system, or connect the negative (-) cable to a ground connection point if available.

Jump Starting

  1. Start the engine of the booster vehicle and rev the engine moderately, or press the accelerator gently to keep your engine speed between 2000 and 3000 RPM, as shown in your tachometer.
  2. Start the engine of the disabled vehicle.
  3. Once the disabled vehicle has been started, run both vehicle engines for an additional three minutes before disconnecting the jumper cables.

Removing the Jumper Cables

Remove the jumper cables in the reverse order that they were connected.

Ford Fusion. Jump Starting the Vehicle

  1. Remove the negative (-) jumper cable from the disabled vehicle.
  2. Remove the jumper cable on the negative (-) terminal of the booster vehicle battery.
  3. Remove the jumper cable from the positive (+) terminal of the booster vehicle battery.
  4. Remove the jumper cable from the positive (+) terminal of the disabled vehicle battery.
  5. Allow the engine to idle for at least one minute.



Hazard Flashers. Fuel Shutoff
Hazard Flashers Note: The hazard flashers operate when the ignition is in any position, or if the key is not in the ignition. If used when the vehicle is not running, the battery loses charge. As ...

Post-Crash Alert System. Transporting the Vehicle
Post-Crash Alert System The system flashes the direction indicators and sounds the horn (intermittently) in the event of a serious impact that deploys an airbag (front, side, side curtain or Safety ...

Other information:

Hyundai Kona (OS) 2018-2021 Owners Manual: Normal Maintenance Schedule (Gasoline Engine, for Europe)
I : Inspect and if necessary, adjust, correct, clean or replace. R : Replace or change. ** : The engine oil level should be checked regularly and maintained properly. Operating with an insufficient amount of oil can damage the engine, and such damage is not covered by warranty. *1 : Inspect driv ...

Hyundai Kona (OS) 2018-2021 Service Manual: AUX jack Description and operation
Description The multimedia jack on the console upper cover is for customers who like to listen to external portable music players like the MP3 etc., through the vehicle's sound system when it is linked to this jack. The customer has this added option. In case of distort ...

© 2018-2021