Hyundai Kona: Body Side Molding / Roof Rack Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Rack Repair procedures

Removal

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Put on gloves to prevent hand injuries.

1.	Remove the roof rack side cap (A).

2.	Loosen the nuts and remove the roof rack assembly (B).

Installation

Install the roof rack assembly (B).

Tightening torque :

3.9 - 4.4 N.m (0.4 - 0.45 kgf.m, 2.9 - 3.3 lb-ft)

•	Tighten mounting nuts as

Roof Rack Components and components location

Components Location 1. Roof rack assembly ...

Sunroof

...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: General safety information and caution
Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbags could accidentally deploy and cause damage or injuries. • ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Limitations of the system
The driver must be cautious in the below situations, because the system may not detect other vehicles or objects in certain circumstances. When a trailer or carrier is installed. The vehicle drives in inclement weather such as heavy rain or snow. The sensor is polluted with rain, snow, mud, etc ...