Hyundai Kona: Steering wheel / Tilt steering / Telescopic steering
WARNING
Never adjust the steering wheel while driving. You may lose steering control and cause severe personal injury, death or accidents.
Information
After adjustment, sometimes the lockrelease lever may not lock the steering wheel.
It is not a malfunction. This occurs when two gears are not engaged correctly. In this case, adjust the steering wheel again and then lock the steering wheel.
Pull down the lock-release lever (1) on the steering wheel column and adjust the steering wheel angle (2) and position (3). Move the steering wheel, so it points toward your chest, not toward your face.
Make sure you can see the instrument panel warning lights and gauges.
After adjusting, pull up the lockrelease lever (1) to lock the steering wheel in place. Push the steering wheel both up and down to be certain it is locked in position. Always adjust the position of the steering wheel before driving.
Electric power steering (EPS)
The system assists you with steering the vehicle. If the engine is off or if
the power steering system becomes inoperative, the vehicle may still be steered,
but it will require increased steering e ...
Heated steering wheel
When the ignition switch is in the ON position or when the engine is running,
press the heated steering wheel button to warm the steering wheel.
The indicator on the button will illuminate. To turn ...
Other information:
Hyundai Kona (OS) 2018-2020 Owners Manual: ISOFIX anchorage and top-tether anchorage (ISOFIX anchorage system) for children
The ISOFIX system holds a Child Restraint System during driving and in an accident.This
system is designed to make installation of the Child Restraint System easier and
reduce the possibility of improperly installing your Child Restraint System. The
ISOFIX system uses anchors in the vehicle and a ...
Hyundai Kona (OS) 2018-2020 Service Manual: Heated Steering wheel Repair procedures
Removal
[Heated Steering Wheel Switch]
1.
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
2.
Remove the floor console upper complete assembly.
(Refer to Body - "Floor Console Assembly" ...