There is a wireless cellular phone charger inside the front console.
The system is available when all doors are closed, and when the ignition switch is in the ACC/ON position.
To charge a cellular phone
The wireless cellular phone charging system charges only the Qi-enabled cellular
phones (). Read the label on the cellular
phone accessory cover or visit your cellular phone manufacturer’s website to check
whether your cellular phone supports the Qi technology.
The wireless charging process starts when you put a Qi-enabled cellular phone on the wireless charging unit.
1. Remove other items, including the smart key, from the wireless charging unit. If not, the wireless charging process may be interrupted. Place the cellular phone on the center of charging pad.
2. The indicator light is orange when the cellular phone is charging. The indicator light turns green when phone charging is complete.
3.You can turn ON or OFF the wireless charging function in the User Settings mode on the instrument cluster. For further information, refer to the “LCD Display Modes” in this chapter.
If your cellular phone is not charging:
- Slightly change the position of the cellular phone on the charging pad.
-
Make sure the indicator light is orange.
The indicator light will blink orange for 10 seconds if there is a malfunction in the wireless charging system.
In this case, temporarily stop the charging process, and re-attempt to wirelessly charge your cellular phone again.
The system warns you with a message on the LCD display if the cellular phone is still on the wireless charging unit after the engine is turned OFF and the front door is opened.
NOTICE
Hyundai Kona (OS) 2018-2024 Service Manual: ETC (Electronic Throttle Control) System Description and operation
Description
The Electronic Throttle Control (ETC) System consists of a throttle body with
an integrated control motor and throttle position sensor (TPS). Instead of the
traditional throttle cable, an Accelerator Position Sensor (APS) is used to
receive driver input. The ECM ...
Hyundai Kona (OS) 2018-2024 Service Manual: Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
3.
Remove the steering column uppe ...