Hyundai Kona: Audio / Antenna Repair procedures

Removal
Roof Antenna
1.
Disconnect the negative (-) battery terminal.
2.
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
3.
Disconnect the roof antenna cable and connector (A) and then remove the antenna mounting nut.

4.
Remove the radio antenna(B).

Installation
Install the radio antenna.
Install the connector and cable.
Install the roof trim.
  
Make sure that the cable and connector are plugged in properly.
Check the audio system for normal operation.
Inspection
Antenna cable
1.
Check for continuity between the center poles of antenna cable.

2.
Check for continuity between the outer poles of antenna cable. There should be continuity.

3.
If there is no continuity, replace the antenna cable.
4.
Check for continuity between the center pole (A) and outer pole (B) of antenna cable. There should be no continuity.

5.
If there is continuity, replace the antenna cable.
Speakers Repair procedures
Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying tha ...

Audio Remote Control Components and components location
Components 1. Left Remote Control Switch (Audio + Hands free) 2. Right Remote Control Switch (Cruise+Trip Computer) ...

Other information:

Hyundai Kona (OS) 2018-2020 Service Manual: Fuel Pressure Sensor (FPS) Description and operation
Description The fuel pressure sensor (FPS) is installed on the top of the low pressure fuel pump and measures the pressure in the low pressure fuel line.Based on the fuel pressure measured by the FPS and the amount of fuel consumed, the fuel pump control module (FPCM) determ ...

Hyundai Kona (OS) 2018-2020 Service Manual: Specifications
Specifications Tightening Torques Items N.m kgf.m lb-ft Transfer assembly mounting bolts 60.8 - 65.7 6.2 - 6.7 44.8 - 48.5 4WD ECM mounting nuts 9.8 - 1 ...

© 2018-2020 www.hkona.com