Hyundai Kona: Disc brakes wear indicator / Anti-lock Brake System (ABS)
An Anti-Lock Braking System (ABS) or an Electronic Stability Control (ESC) system will not prevent accidents due to improper or dangerous driving maneuvers. Even though vehicle control is improved during emergency braking, always maintain a safe distance between you and objects ahead of you. Vehicle speeds should always be reduced during extreme road conditions. The braking distance for vehicles equipped with ABS or ESC may be longer than for those without these systems in the following road conditions. Drive your vehicle at reduced speeds during the following conditions:
- Rough, gravel or snow-covered roads.
- On roads where the road surface is pitted or has different surface height.
- Tire chains are installed on your vehicle.
The safety features of an ABS or ESC equipped vehicle should not be tested by high speed driving or cornering. This could endanger the safety of yourself or others.
ABS is an electronic braking system that helps prevent a braking skid. ABS allows the driver to steer and brake at the same time.
Parking brake
Always set the parking brake before leaving the vehicle, to apply:
Firmly depress the brake pedal.
Pull up the parking brake lever as far as possible.
WARNING
To reduce the risk of SERIOUS INJURY or ...
Using ABS
To obtain the maximum benefit from your ABS in an emergency situation, do not
attempt to modulate your brake pressure and do not try to pump your brakes. Depress
your brake pedal as hard as possible ...
Other information:
Hyundai Kona (OS) 2018-2021 Service Manual: PTC Heater Description and operation
Description
The PTC (Positive Temperature Coefficient) heater is installed at the exit
or the backside of heater core.
The PTC heater is an electric heater using a PTC element as an auxiliary
heating device that supplements deficiency of interior heat source in hi ...
Hyundai Kona (OS) 2018-2021 Service Manual: Brake Pedal Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
3.
Disconnect the stop lamp switch connec ...