Hyundai Kona: Wiper blades / Blade replacement

When the wipers no longer clean adequately, the blades may be worn or cracked, and require replacement.

NOTICE

To prevent damage to the wiper arms or other components, do not attempt to move the wipers manually.

NOTICE

The use of a non-specified wiper blade could result in wiper malfunction and failure.

NOTICE

Type A

1. Lift up the wiper blade clip. Then lift up the wiper blade.

2. While pushing the lock (1), pull down the wiper blade (2).

3. Remove the wiper blade from the wiper arm.

4. Install a new wiper blade assembly in the reverse order of removal.

5. Return the wiper arm on the windshield.

Type B

1. Raise the wiper arm.

2. Lift up the wiper blade clip. Then pull down the blade assembly and remove it.

3. Install the new blade assembly in the reverse order of removal.

4. Return the wiper arm on the windshield.

Rear window wiper blade

1. Raise the wiper arm and pull out the wiper blade assembly.

2. Install the new blade assembly by inserting the center part into the slot in the wiper arm until it clicks into place.

3. Make sure the blade assembly is installed firmly by trying to pull it slightly.

To prevent damage to the wiper arms or other components, we recommend that the wiper blades be replaced by an authorized HYUNDAI dealer.

Blade inspection
Contamination of either the windshield or the wiper blades with foreign matter can reduce the effectiveness of the windshield wipers. Common sources of contamination are insects, tree sap, and hot wa ...

Battery
WARNING To prevent SERIOUS INJURY or DEATH to you or bystanders, always follow these precautions when working near or handling the battery: Always read and follow instructions carefully when handli ...

Other information:

Hyundai Kona (OS) 2018-2023 Service Manual: Cruise Control Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel assembly. (Refer to Steering System - "Steering Wheel") 3. Remove the screws from the steering back cover ...

Hyundai Kona (OS) 2018-2023 Service Manual: Manifold Absolute Pressure Sensor (MAPS) Specifications
Specification Pressure [kPa (kgf/cm², psi)] Output Voltage (V) 32.5 (0.33, 4.71) 0.5 284 (2.90, 41.19) 4.5 ...

© 2018-2023 www.hkona.com