Hyundai Kona: Crash Pad / Cluster Fascia Panel Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body (Interior and Exterior) / Crash Pad / Cluster Fascia Panel Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Using a screwdriver or remover, remove the steering column shroud upper panel (A).

2.	Using a screwdriver or remover, remove the cluster fascia panel (A).

To install, reverse the removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Cluster Fascia Panel Components and components location

Component Location 1. Cluster fascia panel ...

Crash pad garnish assembly [RH] Components and components location

Components Location 1. Crash pad garnish assembly [RH] ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: In case of an emergency while driving
If the engine stalls while driving Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place. Turn on your hazard warning flasher. Try to start the engine again. If your vehicle will not start, we recommend that you contact an authorized HYUNDAI deale ...

Hyundai Kona (OS) 2018-2026 Service Manual: Radiator Repair procedures
Removal and Installation 1. Loosen the drain plug, and drain the coolant and remove the radiator cap to speed draning. (Refer to Cooling System - "Coolant") 2. Remove the cooling fan. (Refer to Cooling Syste ...