Hyundai Kona: Floor Console / Console Armrest Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body (Interior and Exterior) / Floor Console / Console Armrest Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the floor console assembly. (Refer to Floor Console - "Floor Console Assembly")

2.	Remove the rear console cover. (Refer to Floor Console - "Rear Console Cover")

3.	Loosen the mounting screws and remove the console armrest (A).

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Console Armrest Components and components location

Component Location 1. Console armrest ...

Crash Pad

...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Checking the tire inflation pressure
1. After driving approximately 7~10 km (4~6 miles or about 10 min), stop at a safety location. 2. Connect the connection hose (9) of the compressor directly to the tire valve. 3. Plug the compressor power cord into the vehicle power outlet. 4. Adjust the tire inflation pressure to the recomended t ...

Hyundai Kona (OS) 2018-2026 Service Manual: Blower Resistor (Manual) Repair procedures
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) ...