Hyundai Kona: Engine Control System / Crankshaft Position Sensor (CKPS) Description and operation

Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine may stop because of CKPS signal missing.

This sensor is installed in ladder frame and generates alternating current by magnetic flux field which is made by the sensor and the target wheel when the engine rotates. The target wheel consists of 58 slots and 2 missing slots on 360 CA (Crank Angle).

Engine Coolant Temperature Sensor (ECTS) Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Remove the ECTS. (Refer to "Removal") 3. Afte ...

Crankshaft Position Sensor (CKPS) Troubleshooting

Waveform This example shows a typical Crankshaft Position Sensor(CKPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Troubleshooting
Troubleshooting Problem Symptoms Table Use the table below to help you find the cause of the problem. The numbers indicate the priority of the like cause of the problem. Check each part in order. If necessary, replace these parts. Symptom ...

Hyundai Kona (OS) 2018-2026 Service Manual: Description and operation
Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp for a LED lamp check. The lamp shall turn on for 6 seconds during the initialization ...