Hyundai Kona: Maintenance / Engine coolant
The high-pressure cooling system has a reservoir filled with year-round antifreeze coolant. The reservoir is filled at the factory.
Check the antifreeze protection and coolant concentration level at least once a year, at the beginning of the winter season, and before traveling to a colder climate.
NOTICE
- When the engine overheats from low engine coolant, suddenly adding engine coolant may cause cracks in the engine. To prevent damage, add engine coolant slowly in small quantities.
- Do not drive with no engine coolant. It may cause water pump failure and engine seizure, etc.
Engine oil
Checking the engine oil level (Gasoline engine)
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for ...
Checking the engine coolant level
Check the condition and connections of all cooling system hoses and heater hoses.
Replace any swollen or deteriorated hoses.
The coolant level should be filled between MAX and MIN (or F (Full) and L ...
Other information:
Hyundai Kona (OS) 2018-2026 Service Manual: Blower Motor Repair procedures
Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor does not operate well, substitute with a known-good
blower motor and check for proper operation.
...
Hyundai Kona (OS) 2018-2026 Service Manual: Rear Shock Absorber Repair procedures
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from front hub.
Tightening torque :
107.9 - 127.5 N ...
