| Replacement |
| 1. |
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
|
| 2. |
Remove the front door belt inside weatherstrip (A).
|
| 3. |
After loosening the mounting screws, remove the front door full handle
mounting support (A).
|
| 4. |
Disconnect the front door speaker connector (A).
|
| 5. |
Remove the front door trim seal (A).
|
| 6. |
By operating the power window switch, pull down until the glass mounting
bolt on plug hole is visible.
|
| 7. |
Loosen the mounting bolt and then pull out the front door window glass
(A) by tilting it sideways.
|
| 8. |
To install, reverse removal procedure.
|
Front Door Window Glass Components and components location
Front Door Power Window Regulator Components and components locationHyundai Kona (OS) 2018-2026 Service Manual: Rear Differential Carrier Repair procedures
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque :
107.9 - 127.5 N. ...
Hyundai Kona (OS) 2018-2026 Service Manual: Fuel Pressure Control Valve (FPCV) Specifications
Specification
Item
Specification
Coil Resistance (Ω)
0.5 [20°C (68°F)
...