Hyundai Kona: AVN System / AVN Antenna Repair procedures

Removal
Roof Antenna
1.
Disconnect the negative (-) battery terminal.
2.
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
3.
Disconnect the roof antenna cable and connector (A) and then remove the antenna mounting nut.

4.
Remove the radio antenna (B).

WI-FI & LTE antenna
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crashpad.
(Refer to Body - "Crashpad")
3.
Remove the WIFI & LTE antenna(A) after disconneting the connector.

Installation
Roof Anenna
1.
Connect the roof antenna connectors.
2.
Install the roof trim assembly.
  
Make sure that the cables and connectors are plugged in properly.
Check the audio system.
AVN Antenna Components and components location
Components [Roof Antenna (GPS)] ...

Speaker Repair procedures
Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying tha ...

Other information:

Hyundai Kona (OS) 2018-2024 Service Manual: Fuel Pressure Sensor (FPS) Description and operation
Description The fuel pressure sensor (FPS) is installed on the top of the low pressure fuel pump and measures the pressure in the low pressure fuel line.Based on the fuel pressure measured by the FPS and the amount of fuel consumed, the fuel pump control module (FPCM) determ ...

Hyundai Kona (OS) 2018-2024 Service Manual: Repair procedures
Replacement 1. Remove the plug hole (A). 2. Remove the cap and the nuts, and then remove the wiper arm (A). Tightening torque : 22.6 - 26.5 N.m (2.3 - 2.7 kgf.m, 16.6 - 19.5 lb-ft) ...

© 2018-2024 www.hkona.com