Hyundai Kona: Lift and Support Points / General information

Hyundai Kona (OS) 2018-2025 Service Manual / General Information / Lift and Support Points / General information

Lift and Support Points

•

When heavy rear components such as suspension, fuel tank, spare tire, tailgate and trunk lid are to be removed, place additional weight in the luggage area before hoisting. When substantial weight is removed from the rear of the vehicle, the center of gravity may change and can cause the vehicle to tip forward on the hoist.

•	With each tire/wheel assembly weighing approximately 30lbs (14kg), placing the front wheels in the luggage area can help the weight distribution.

•	Use the same support points to support the vehicle on safety stands.

1.	Place the lift blocks under the support points as shown in the illustration.

2.	Raise the hoist a few inches (centimeters) and rock the vehicle to make sure that the vehicle is firmly supported.

3.	Raise the hoist to full height to check whether the vehicle is firmly supported.

Lift and Support Points

...

Towing

...

Other information:

Hyundai Kona (OS) 2018-2025 Service Manual: Blower Unit Components and components location
Component Location 1. Blower unit assembly Components 1. Intake seal 2. Intake duct case 3. Intake actuator 4. Intake door 5. Intake lower case 6. Air filter 7. Air filter co ...

Hyundai Kona (OS) 2018-2025 Service Manual: Rear Door Outside Handle Repair procedures
Replacement 1. Remove the plug hole. 2. After loosening the mounting bolt, remove the rear door outside handle cover (A). Tightening torque : 7.8 - 10.8 N.m (0.8 - 1.1 kgf.m, 5.8 - 8.0 lb-ft) ...