When the tire pressure monitoring system warning indicator is illuminated and warning message displayed on the cluster LCD display, one or more of your tires is significantly under-inflated.
If the telltale illuminates, immediately reduce your speed, avoid hard cornering and anticipate increased stopping distances. You should stop and check your tires as soon as possible. Inflate the tires to the proper pressure as indicated on the vehicle's placard or tire inflation pressure label located on the driver's side center pillar outer panel. If you cannot reach a service station or if the tire cannot hold the newly added air, replace the low pressure tire with the spare tire.
Then the Low Tire Pressure telltale may flash for approximately one minute and then remain continuously illuminated after restarting and about 10 minutes of continuous driving before you have the low pressure tire repaired and replaced on the vehicle.
CAUTION
In winter or cold weather, the low tire pressure telltale may be illuminated if the tire pressure was adjusted to the recommended tire inflation pressure in warm weather. It does not mean your TPMS is malfunctioning because the decreased temperature leads to a proportional lowering of tire pressure.
When you drive your vehicle from a warm area to a cold area or from a cold area to a warm area, or the outside temperature is greatly higher or lower, you should check the tire inflation pressure and adjust the tires to the recommended tire inflation pressure.
WARNING
Low pressure damage Significantly low tire pressure makes the vehicle unstable and can contribute to loss of vehicle control and increased braking distances.
Continued driving on low pressure tires can cause the tires to overheat and fail.
Hyundai Kona (OS) 2018-2024 Service Manual: Steering Gear Box Repair procedures
Removal
1.
Loosen the wheel nuts slightly.
2.
Raise the vehicle, and make sure it is securely supported.
3.
Remove the front wheel and tire (A) from front hub.
Tightening torque :
...
Hyundai Kona (OS) 2018-2024 Service Manual: Shift Lever Repair procedures
Removal
1.
Remove the shift lever knob & boots (A) pull both of it up.
2.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
3.
Remove the fixing clip of wiring ( ...