Hyundai Kona: Airbag Module / Passenger Airbag (PAB) Module Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Restraint / Airbag Module / Passenger Airbag (PAB) Module Repair procedures

Removal

1.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

2.	Remove the glove box housing. (Refer to Body - "Glove Box Upper Cover Assembly")

3.	Remove the passenger airbag mounting bolts.

4.	Disconnect the passenger airbag connector (A).

Remove the crash pad.

(Refer to Body - "Main Crash Pad Assembly")

•	Replace the crash pad which that has been damaged after the PAB has been deployed.

Remove the passenger airbag from the crash pad after loosening the mounting bolts.

•	The removed airbag module should be stored in a clean, dry place with the airbag cushion up.

Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.

Place the passenger airbag on the crash pad and tighten the passenger airbag mounting bolts.

Tightening torque :

4.0 - 6.0 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.4 lb-ft)

4.	Install the crash pad. (Refer to Body - "Main Crash Pad Assembly")

5.	Connect the passenger airbag harness connector to the SRS main harness connector (A).

Tighten the passenger airbag crash pad mounting bolts.

Tightening torque :

7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

7.	Install the glove box. (Refer to Body - "Crash Pad Center Panel")

8.	Connect the battery negative cable.

After installing the passenger airbag (PAB), confirm proper system operation :

•	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Passenger Airbag (PAB) Module Description and operation

Description The passenger airbag (PAB) is installed inside the crash pad and protects the front passenger in the event of a frontal crash. The SRSCM determines if and when to dep ...

Side Airbag (SAB) Module Components and components location

Components 1. Side Air Bag (SAB) ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Description and operation
Description The Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH & RH). When a vehicle crashes with a certain degree of frontal impact, the pretensioner seat belt helps to reduce the severity of injury to the front seat occupants by retracting the sea ...

Hyundai Kona (OS) 2018-2026 Service Manual: Troubleshooting
Troubleshooting Symptom Suspect area Remedy Engine misfire with abnormal internal lower engine noises. Loose or improperly installed engine flywheel. Repair or replace the flywheel as required. ...