Hyundai Kona: To activate the ISG system / Prerequisite for activation

The ISG system operates in the following situations.

- The driver's seatbelt is fastened.
- The driver's door and the hood are closed.
- The brake vacuum pressure is adequate.
- The battery is sufficiently charged.
- The outside temperature is between -20 °C and 35 °C (-4 °F and 95 °F).
- The engine coolant temperature is not too low.
- The system is not in the diagnostic mode.
- The steering wheel is not steered excessively. (for dual clutch transmission vehicle)
- The vehicle is driven on a steep incline. (for dual clutch transmission vehicle)

Information

To activate the ISG system
...

Auto stop
To stop the engine in idle stop mode Manual transmission vehicle 1. Decrease the vehicle speed to 5 km/h (3 mph). 2. Set the gear in N (Neutral). 3. Release the clutch pedal. The auto stop indicator ...

Other information:

Hyundai Kona (OS) 2018-2020 Service Manual: Ignition Coil Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the engine cover. 3. Disconnect the ignition coil connector (A). ...

Hyundai Kona (OS) 2018-2020 Owners Manual: Distributing the sealant
9. Immediately drive approximately 7~10 km (4~6 miles or, about 10min) to evenly distribute the sealant in the tire. Do not exceed a speed of 80 km/h (50 mph). If possible, do not fall below a speed of 20 km/h (12 mph). While driving, if you experience any unusual vibration, ride disturbance or ...

© 2018-2020 www.hkona.com