Hyundai Kona: Seat belt restraint system / Rear center seatbelt (3-point rear center seat belt)
1.Insert the tongue plate (1) into the buckle (2) until an audible “click" is heard, indicating the latch is locked. Make sure the belt is not twisted.
When using the rear center seat belt, the buckle with the “CENTER” mark must be used.
WARNING
Always have the metal tab inserted into the buckle.
Information
If you are not able to pull out the safety belt from the retractor, firmly pull the belt out and release it. After release, you will be able to pull the belt out smoothly.
Lap/shoulder belt
To fasten your seat belt:
Pull it out of the retractor and insert the metal tab (1) into the buckle (2).
There will be an audible "click" when the tab locks into the buckle.
The seat belt automatica ...
Pre-tensioner seat belt
Your vehicle is equipped with driver's and front passenger's and rear passengers
(if equipped) Pre-tensioner Seat Belts (Retractor Pretensioner).
The purpose of the pre-tensioner is to make sure the ...
Other information:
Hyundai Kona (OS) 2018-2026 Service Manual: Fuel Pump Control Module (FPCM) Schematic diagrams
Circuit Diagram
Terminal Illustration
Terminal Function
Pin No
Description
Connected to
1
Fuel sender ground (-)
Fuel Pump
2
Fuel pressure sensor ...
Hyundai Kona (OS) 2018-2026 Service Manual: BJ Boot Components and components location
Components (1)
[Gamma 1.6 T-GDI, Nu 2.0 MPI]
1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
11. Snap ring
12. TJ case
...
