Hyundai Kona: Rear Door / Rear Door Outside Handle Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Outside Handle Repair procedures

Replacement

1.	Remove the plug hole.

After loosening the mounting bolt, remove the rear door outside handle cover (A).

Tightening torque :

7.8 - 10.8 N.m (0.8 - 1.1 kgf.m, 5.8 - 8.0 lb-ft)

3.	Remove the rear door outside handle (A) by pushing it in the direction of arrow.

To install, reverse removal procedure.

•	Make sure the door locks / unlocks and opens / closes properly.

•	Be sure to install the outside handle pad (A) between the outside handle and the door panel.

Rear Door Outside Handle Components and components location

Component Location 1. Rear door outside handle ...

Rear Door Latch Components and components location

Component Location 1. Rear door latch ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Air bags
You can take steps to reduce the risk of being injured by an inflating air bag. Sitting too close to an air bag greatly increases the risk of injury in the event the air bag inflates. Move your seat as far back as possible from front air bags, while still maintaining control of the vehicle. WARNI ...

Hyundai Kona (OS) 2018-2026 Service Manual: Ambient Temperature Sensor (ATS) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the ATS connector. 3. Measure resistance between the ATS terminals 1 and 2 [B1/S1]. 4. Check that the resistance is within ...