Hyundai Kona: Rear Door / Rear Door Power Window Regulator Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Power Window Regulator Repair procedures

Replacement

1.	Remove the rear door window glass. (Refer to Rear Door - "Rear Door Window Glass")

2.	Disconnect the rear door power window motor connector (A).

Loosen the rear door power window regulator mounting nuts.

Tightening torque :

3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)

4.	Remove the rear door power window regulator assembly (A).

To install, reverse removal procedure.

•	Make sure connectors are connected properly and each rod is connected securely.

•	Make sure the door locks / unlocks and opens / closes properly.

Rear Door Power Window Regulator Components and components location

Component Location 1. Rear door power window regulator ...

Rear Door Outside Handle Components and components location

Component Location 1. Rear door outside handle ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Components and components location
Components Location 1. Rear shock absorber 2. Coil spring 3. Torsion beam axle 4. Torsion beam axle stay ...

Hyundai Kona (OS) 2018-2026 Service Manual: General safety information and caution
Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbags could accidentally deploy and cause damage or injuries. • ...