1. Open the tailgate, and remove the towing hook from the tool case.
2. Remove the hole cover pressing the lower part of the cover on the bumper.
3. Install the towing hook by turning it clockwise into the hole until it is fully secured.
4. Remove the towing hook and install the cover after use.
Hyundai Kona (OS) 2018-2021 Service Manual: Repair procedures
Inspection
ESP System Bleeding
This procedure should be followed to ensure adequate bleeding of air and filling
of the ESC unit, brake lines and master cylinder with brake fluid.
1.
Remove the reservoir cap and fill the brake reservoir with brake fluid.
...
Hyundai Kona (OS) 2018-2021 Service Manual: Temperature Control Actuator Description and operation
Description
The temperature control actuator is located at the heater unit. It regulates
the temperature by the procedure as follows.
The signal from the control unit adjusts the position of the temperature
door by operating the temperature switch. Then the tempe ...