Hyundai Kona: Sunroof / Sliding the sunroof
Pressing the sunroof control lever backward or forward momentarily to the second detent position completely opens or closes the sunroof even when the switch is released. To stop the sunroof at the desired position while the sunroof is in operation, press the sunroof control lever backward or forward and release the switch.
Information
To reduce wind noise while driving, it is recommended that you drive with the sunroof slightly closed (stop the sunroof about 7 cm before the maximum slide open position).
Sunroof opening and closing
To open:
Press the sunroof control lever backward to the first detent position. Release
the switch when you want the sunroof to stop.
To close:
Press the sunroof control lever forward to the first d ...
Automatic reverse
If the sunroof senses any obstacle while it is closing automatically, it will
reverse direction then stop to allow the object to be cleared.
The auto reverse function does not work if a small obstac ...
Other information:
Hyundai Kona (OS) 2018-2026 Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Waveform
This example shows a typical Crankshaft Position Sensor(CKPS) and Camshaft Position
Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing
by using these signals.
Generally CKPS signal is used to detect the piston's position a ...
Hyundai Kona (OS) 2018-2026 Service Manual: CVVT Oil Control Valve (OCV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the spec ...
