Operates as follows when the ignition switch is turned ON.
/MIST : For a single wiping cycle,
move the lever down ( ) or up (MIST) and release it. The wipers will operate continuously
if the lever is held in this position.
O/OFF : Wiper is not in operation
---/INT : Wiper operates intermittently at the same wiping intervals. Use this mode in light rain or mist. To vary the speed setting, turn the speed control knob.
1/LO : Normal wiper speed
2/HI : Fast wiper speed
Information
If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation.
If you do not remove the snow and/or ice before using the wiper and washer, it may damage the wiper and washer system.
AUTO (Automatic) control
.png)
The rain sensor located on the upper end of the windshield glass senses the amount of rainfall and controls the wiping cycle for the proper interval. The more it rains, the faster the wiper operates.
When the rain stops, the wiper stops. To vary the speed setting, turn the speed control knob (1).
If the wiper switch is set in AUTO mode when the ignition switch is in the ON position, the wiper will operate once to perform a self-check of the system. Set the wiper to OFF position when the wiper is not in use.
WARNING
To avoid personal injury from the windshield wipers, when the engine is running and the windshield wiper switch is placed in the AUTO mode:
NOTICE
Wipers and washers
Windshield washersHyundai Kona (OS) 2018-2026 Owners Manual: System setting and activation
System setting
The Driver Attention Warning (DAW) system is set to be in the OFF position,
when your vehicle is first delivered to you from the factory.
To turn ON the Driver Attention Warning (DAW) system, turn on the engine,
and then select "User Settings Driver Assistance Driver Attention ...
Hyundai Kona (OS) 2018-2026 Owners Manual: Windshield washers
In the OFF (O) position, pull the lever gently toward you to spray washer fluid
on the windshield and to run the wipers 1-3 cycles.
The spray and wiper operation will continue until you release the lever.
If the washer does not work, you may need to add washer fluid to the washer fluid
reservoir. ...