Hyundai Kona: Wipers and washers / Windshield washers

In the OFF (O) position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles.

The spray and wiper operation will continue until you release the lever.

If the washer does not work, you may need to add washer fluid to the washer fluid reservoir.

If equipped with the Headlamp

Washer, washer fluid will be sprayed on the headlamp at the same time you operate the windshield washer when:

1. The ignition switch is in the ON position.

2. The light switch is in the headlamp position.

WARNING

When the outside temperature is below freezing, ALWAYS warm the windshield using the defroster to prevent the washer fluid from freezing on the windshield and obscuring your vision which could result in an accident and serious injury or death.

CAUTION

Windshield wipers
Operates as follows when the ignition switch is turned ON. /MIST : For a single wiping cycle, move the lever down ( ) or up (MIST) and release it. The wipers will operate continuously if the lever i ...

Rear window wiper and washer switch
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to the desired position to operate the rear wiper and washer. 2 / HI – High wipe ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Ignition Coil Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the engine cover. 3. Disconnect the ignition coil connector (A). ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Vehicle Stability Management
The Vehicle Stability Management (VSM) is a function of the Electronic Stability Control (ESC) system. It helps ensure the vehicle stays stable when accelerating or braking suddenly on wet, slippery and rough roads where traction over the four tires can suddenly become uneven. WARNING Take the fo ...

© 2018-2026 www.hkona.com