Hyundai Kona: Wipers and washers / Rear window wiper and washer switch

The rear window wiper and washer switch is located at the end of the wiper and washer switch lever.

Turn the switch to the desired position to operate the rear wiper and washer.

2 / HI – High wiper speed
1 / LO – Low wiper speed
O / OFF – Off

Push the lever away from you to spray rear washer fluid and to run the rear wipers 1~3 cycles. The spray and wiper operation will continue until you release the lever. (if equipped)

Auto rear wiper (if equipped)

The rear wiper will operate while the vehicle is in reverse with the front wiper ON by selecting the function on the LCD display.

Go to ‘User Settings Convenience Auto Rear Wiper (reverse)’.

Windshield washers
In the OFF (O) position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. The spray and wiper operation will continue until you release the ...

Driver assist system
...

Other information:

Hyundai Kona (OS) 2018-2022 Service Manual: Rear Seat Assembly Repair procedures
Replacement [Rear seat cushion assembly] 1. Remove the luggage covering board (A). 2. Remove the luggage floor center tray assembly (A). 3. Pull up the rear seat back assembly (A) by pulling ...

Hyundai Kona (OS) 2018-2022 Service Manual: Exhaust Gas Temperature Sensor (EGTS) Description and operation
Description Installed in exhaust manifold, the Exhaust Gas Temperature Sensor (EGTS) #1 for WGT senses the temperature of exhaust gas flowing into the WGT. Installed in Gasoline Particulate Filter (GPF) assembly, the Exhaust Gas Temperature Sensor (EGTS) #2 for GPF senses t ...

© 2018-2022 www.hkona.com