Hyundai Kona: Heating and air conditioning / Air intake control (7)

This is used to select outside (fresh) air position or recirculated air position. To change the air intake control position, press the control button.

Recirculated air position

With the recirculated air position selected, air from the passenger compartment will be drawn through the heating system and heated or cooled according to the function selected.

Outside (fresh) air position

With the outside (fresh) air position selected, air enters the vehicle from outside and is heated or cooled according to the function selected.

Information

Using the system in the fresh air position is recommended.

Prolonged operation of the heater in the recirculated air position (without air conditioning selected) can cause fogging of the windshield and side windows and the air within the passenger compartment will become stale.

In addition, prolonged use of the air conditioning with the recirculated air position selected will result in excessively dry air in the passenger compartment.

WARNING

Temperature control (2)
The temperature will increase by turning the knob to the right. The temperature will decrease by turning the knob to the left. ...

Fan speed control (1)
Turn the knob to the right to increase the fan speed and airflow. Turn the knob to the left to decrease fan speed and airflow. Setting the fan speed control knob to the “0” position turns off the ...

Other information:

Hyundai Kona (OS) 2018-2019 Owners Manual: Prerequisites to reactivate the battery sensor
Keep the engine in the OFF status for 4 hours, and attempt to restart the engine 3 to 4 times for the batterysensor reactivation. Pay extreme caution not to connect any accessories (i.e. navigation and black box) to the vehicle with the engine in the OFF status. If not, the battery sensor may not ...

Hyundai Kona (OS) 2018-2019 Service Manual: Blower Resistor (Manual) Repair procedures
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) ...

© 2018-2019 www.hkona.com