Hyundai Kona: ISG (Idle Stop & Go) System / Alternator Schematic diagrams

Hyundai Kona (OS) 2018-2020 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Alternator Schematic diagrams

Circuit Diagram

•	COM signal - LIN communication control

•	B+ Terminal - The output voltage from the generator travels to the battery via the B+ terminal.

Alternator Components and components location

Components 1. Nut 2. Pulley 3. Front housing 4. Front bearing 5. Retainer 6. Rotor 7. Rear bearing 8. Stator 9. Rear housing 10. Regulator ...

Alternator Repair procedures

Removal 1. Turn ignition switch OFF and disconnect the battery negative (-) battery. 2. Disconnect the alternator "B" terminal (A ...

Other information:

Hyundai Kona (OS) 2018-2020 Service Manual: Rear Driveshaft Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque : 107.9 - 127.5 N. ...

Hyundai Kona (OS) 2018-2020 Owners Manual: Washer fluid
Checking the washer fluid level Check the fluid level in the washer fluid reservoir and add fluid if necessary. Plain water may be used if washer fluid is not available. However, use washer solvent with antifreeze characteristics in cold climates to prevent freezing. WARNING To prevent serious in ...