Hyundai Kona: Auto Head Lamp Leveling Device / Auto Head Lamp Leveling Unit Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body Electrical System / Auto Head Lamp Leveling Device / Auto Head Lamp Leveling Unit Repair procedures

Inspection

1.	Ignition "ON".

2.	Turn on the head lamp switch.

3.	Check that the aim of the head lamp changes smoothly when the head lamp leveling device switch is turned on.

4.	If it does not operate well, check the connector and terminals to make sure that they are connected. If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system. If the terminal is in good condition, move to the step 5.

5.	Replace the head lamp assembly and check for proper operation.

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the head lamp leveling unit linkage. [2WD] [4WD]

Installation

1.	Install the head lamp leveling unit.

2.	Reconnect the head lamp leveling unit connector.

Auto Head Lamp Leveling Unit Description and operation

Description According to driving environment and loading state of vehicle, head lamp lighting direction is changed to keep the driver's visibility range and to protec ...

Auto Head Lamp Leveling Unit Troubleshooting

Inspection with GDS Initialization and diagnosis sequence by using GDS equipment. The following is the summarized A/S procedure. No Pr ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Hood Latch Components and components location
Component Location 1. Hood latch assembly ...

Hyundai Kona (OS) 2018-2026 Service Manual: TJ Joint Components and components location
Components (1) [Gamma 1.6 T-GDI, Nu 2.0 MPI] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 11. Snap ring 12. TJ case ...