Hyundai Kona: Power windows / Automatic reverse
If a window senses any obstacle while it is closing automatically, it will stop and lower approximately 30 cm (12 inches) to allow the object to be cleared.
If the window detects the resistance while the power window switch is pulled up continuously, the window will stop upward movement then lower approximately 2.5 cm (1 inch).
If the power window switch is pulled up continuously again within 5 seconds after the window is lowered by the automatic window reverse feature, the automatic window reverse will not operate.
Information
The automatic reverse feature is only active when the “Auto Up” feature is used by fully pulling up the switch to the second detent.
WARNING
Make sure body parts or other objects are safely out of the way before closing the windows to avoid injuries or vehicle damage. Objects less than 4 mm (0.16 inch) in diameter caught between the window glass and the upper window channel may not be detected by the automatic reverse window and the window will not stop and reverse direction.
NOTICE
Do not install any accessories on the windows. The automatic reverse feature may not operate.
To reset the power windows
If the power windows do not operate normally, the automatic power window system
must be reset as follows:
1. Place the ignition switch to the ON position.
2. Close the window and continue pulling up ...
Power window lock switch
The driver can disable the power window switches on the rear passengers' doors
by pressing the power window lock switch.
When the power window lock switch is pressed:
The driver's master control c ...
Other information:
Hyundai Kona (OS) 2018-2026 Service Manual: Components and components location
Components
The following is the configuration of the FCA system.
–
Detection device (radar and camera) that can recognize potential obstacles
in the front.
–
Human-Machine Interface (HMI) to warn driver or change settings.
...
Hyundai Kona (OS) 2018-2026 Owners Manual: Normal Maintenance Schedule (Gasoline Engine, for Europe)
I : Inspect and if necessary, adjust, correct, clean or replace. R : Replace
or change. ** : The engine oil level should be checked regularly and maintained
properly. Operating with an insufficient amount of oil can damage the engine, and
such damage is not covered by warranty. *1 : Inspect driv ...
