Hyundai Kona: Power windows / To reset the power windows
If the power windows do not operate normally, the automatic power window system must be reset as follows:
1. Place the ignition switch to the ON position.
2. Close the window and continue pulling up on the power window switch for at least one second.
If the power windows do not operate properly after resetting, it is recommended that the system be checked by an authorized HYUNDAI dealer.
WARNING
The automatic reverse feature doesn’t activate while resetting power window system. Make sure body parts or other objects are safely out of the way before closing the windows to avoid injuries or vehicle damage.
Auto up/down window
Auto down window
Pressing the power window switch momentarily to the second detent position (6)
completely lowers the window even when the switch is released. To stop the window
at the desired posit ...
Automatic reverse
If a window senses any obstacle while it is closing automatically, it will stop
and lower approximately 30 cm (12 inches) to allow the object to be cleared.
If the window detects the resistance whil ...
Other information:
Hyundai Kona (OS) 2018-2026 Service Manual: Rear Seat Assembly Repair procedures
Replacement
[Rear seat cushion assembly]
1.
Remove the luggage covering board (A).
2.
Remove the luggage floor center tray assembly (A).
3.
Pull up the rear seat back assembly (A) by pulling ...
Hyundai Kona (OS) 2018-2026 Service Manual: Propeller Shaft Components and components location
Components
1. Rear drive shaft (LH)
2. Coupling assembly
3. Rear differential carrier assembly
4. Rear drive shaft (RH)
5. Propeller shaft assembly
...
