Hyundai Kona: Smart key / Battery replacement
If the Smart Key is not working properly, try replacing the battery with a new one.
Battery Type: CR2032
To replace the battery:
1. Remove the mechanical key.
2. Use a slim tool to pry open the rear cover
of the smart key.
3. Remove the old battery and insert the new battery. Make sure
the battery position is correct.
4. Reinstall the rear cover of the smart key.
If you suspect your smart key might have sustained some damage, or you feel your smart key is not working correctly, it is recommended that you contact an authorized HYUNDAI dealer.
Information
An inappropriately disposed battery can be harmful to the environment and human health. Dispose of the battery according to your local law(s) or regulations.
Smart key precautions
The smart key may not work if any of the following occur:
The smart key is close to a radio transmitter such as a radio station
or an airport which can interfere with normal operation of the trans ...
Immobilizer system
The immobilizer system protects your vehicle from theft. If an improperly coded
key (or other device) is used, the engine’s fuel system is disabled.
When the ignition switch is placed in the ON pos ...
Other information:
Hyundai Kona (OS) 2018-2026 Owners Manual: Seat belt safety precautions
Always fasten your seat belt and make sure all passengers have fastened their
seat belts before starting any trip. Air bags are designed to supplement the seat
belt as an additional safety device, but they are not a substitute. Most countries
require all occupants of a vehicle to wear seat belts. ...
Hyundai Kona (OS) 2018-2026 Service Manual: Vacuum Pump Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Check the safty after uplift the vehicle with lift.
3.
Remove the under cover.
(Refer to Engine Mechanical System - ...
