Hyundai Kona: Smart key / Smart key precautions

The smart key may not work if any of the following occur:

If the smart key does not work correctly, open and close the door with the mechanical key. If you have a problem with the smart key, it is recommended that you contact an authorized HYUNDAI dealer.

If the smart key is in close proximity to your mobile phone, the signal could be blocked by your mobile phone’s normal operational signals. This is specifically relevant when the phone is active such as making and receiving calls, text messaging, and/or sending/receiving emails.

Avoid placing the smart key and your mobile phone in the same location and always try to maintain an adequate distance between the two devices.

Information

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. If the keyless entry system is inoperative due to changes or modifications not expressly approved by the party responsible for compliance, it will not be covered by your manufacturer’s vehicle warranty.

NOTICE

Keep the smart key away from electromagnetic materials that blocks electromagnetic waves to the key surface.

NOTICE

Always have the smart key with you when leaving the vehicle. If the smart key is left near the vehicle, the vehicle battery may be discharged.

Loss of a smart key
A maximum of two smart keys can be registered to a single vehicle. If you happen to lose your smart key, it is recommended that you should immediately take the vehicle and remaining key to your auth ...

Battery replacement
If the Smart Key is not working properly, try replacing the battery with a new one. Battery Type: CR2032 To replace the battery: 1. Remove the mechanical key. 2. Use a slim tool to pry open the rear ...

Other information:

Hyundai Kona (OS) 2018-2019 Service Manual: Cruise Control Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel assembly. (Refer to Steering System - "Steering Wheel") 3. Remove the screws from the steering back cover ...

Hyundai Kona (OS) 2018-2019 Service Manual: Specifications
Specification Item Specification Power source 3V Operating temperature -10°C ~ to 60°C (14°F to 140°F) RF Modulation FSK ...

© 2018-2019 www.hkona.com