Hyundai Kona: Engine Control System / Boost Pressure Sensor (BPS) Description and operation

The Boost Pressure Sensor (BPS) is installed on the intercooler assembly and measures the pressure of the compressed air in turbocharger.

Ambient Temperature Sensor (ATS) Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the ATS connector. 3. Measure resistance between the ...

Boost Pressure Sensor (BPS) Specifications

Specification Pressure [kPa (kg/cm² / psi)] Resistance (kΩ) 32.5 (0.33, 4.71) 0.5 284 (2.90, 41.19) ...

Other information:

Hyundai Kona (OS) 2018-2020 Service Manual: Power Window Motor Repair procedures
Inspection    • Wrap the protective tape on the tool to disassemble with the screwdriver or remover. • ...

Hyundai Kona (OS) 2018-2020 Service Manual: Temperature Control Actuator Description and operation
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the tempe ...