Hyundai Kona: Engine Control System / Ambient Temperature Sensor (ATS) Repair procedures
| Inspection |
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the ATS connector.
|
| 3. |
Measure resistance between the ATS terminals 1 and 2 [B1/S1].
|
| 4. |
Check that the resistance is within the specification.
|
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
|
| 2. |
Remove the front bomper.
(Refer to Body - "Front Bumper")
|
| 3. |
Disconnect the connector, an then remove the ambient temperature sensor
(A).
|
| Installation |
|
| 1. |
Install in the reverse order of removal.
|
Ambient Temperature Sensor (ATS) Schematic diagrams
Circuit Diagram
Harness Connector
...
Boost Pressure Sensor (BPS) Description and operation
Description
The Boost Pressure Sensor (BPS) is installed on the intercooler assembly and
measures the pressure of the compressed air in turbocharger.
...
Other information:
Hyundai Kona (OS) 2018-2026 Service Manual: Description and operation
Description
The Tire Pressure Monitoring System (TPMS) monitors the pressure and temperature
inside the tire in order to warn the driver of changes in pressure which may
influence the operation of the vehicle. The TPMS control module analyzes wireless
information fro
In ...
Hyundai Kona (OS) 2018-2026 Owners Manual: For safe 4WD operation
Before driving
Make sure all passengers are wearing seat belts.
Sit upright and closer to the steering wheel than usual. Adjust the steering
wheel to a position comfortable for you to drive.
Driving on snow-covered or icy roads
Start off slowly by applying the accelerator pedal gently.
Use ...
