Hyundai Kona: Engine Control System / Camshaft Position Sensor (CMPS) Description and operation

Hyundai Kona (OS) 2018-2020 Service Manual / Engine Control / Fuel System / Engine Control System / Camshaft Position Sensor (CMPS) Description and operation

Description
Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element.
It is related with Crankshaft Position Sensor (CKPS) and detects the piston position of each cylinder which the CKPS can't detect.
The CMPS is installed on engine head cover and uses a target wheel installed on the camshaft. The Cam Position sensor is a hall-effect type sensor. As the target wheel passes the Hall sensor, the magnetic field changes in the sensor. The sensor then switches a signal which creates a square wave.

Crankshaft Position Sensor (CKPS) Repair procedures
Inspection 1. Check signal waveform of CKPS and CMPS using a GDS. Specification : Refer to "Waveform" ...

Camshaft Position Sensor (CMPS) Troubleshooting
Wave Form ...

Other information:

Hyundai Kona (OS) 2018-2020 Owners Manual: Engine oil
Checking the engine oil level (Gasoline engine) 1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to return to the oil pan. 4. Pull the dipstick out, wip ...

Hyundai Kona (OS) 2018-2020 Service Manual: Engine Room Under Cover Repair procedures
Removal and Installation 1. Loosen the mounting clip and bolt and then remove the under cover (A). Tightening torque : 3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 Ib-ft) 2. Insta ...

© 2018-2020 www.hkona.com