Hyundai Kona: Interior Trim / Cowl Side Trim Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the front door scuff trim. (Refer to Interior Trim - "Door Scuff Trim")

2.	Remove the hood latch release handle. (Refer to Hood - "Hood Latch Release Handle")

3.	Carefully remove the front door body side weatherstrip.

4.	Using a screwdriver or remover, remove the cowl side trim (A).

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Component Location 1. Cowl side trim ...

Component Location 1. Front pillar trim ...

Hyundai Kona (OS) 2018-2025 Service Manual: Input shaft speed sensor 1 Repair procedures
Removal 1. Remove the cleaner assembly and air duct. (Refer to Engine Mechainical System - "Air Cleaner") 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") ...

Hyundai Kona (OS) 2018-2025 Service Manual: ETC (Electronic Throttle Control) System Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Specification : Refer t ...