Hyundai Kona: Crash Pad / Crash Pad Side Cover Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body (Interior and Exterior) / Crash Pad / Crash Pad Side Cover Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Using a screwdriver or remover, remove the crash pad side cover (A). [LH] [RH]

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Crash Pad Side Cover Components and components location

Component Location [LH] 1. Crash pad side cover [LH] [RH] 1. Crash pad side cover [RH] ...

Glove Box Components and components location

Component Location 1. Glove box ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Description and operation
Description The Dual Clutch Transmission (DCT) control system measures required data to identify the state of the control target and computes the appropriate compensation value if adjustment is necessary. The actuator is controlled according to the computed compensation valu ...

Hyundai Kona (OS) 2018-2026 Service Manual: Repair procedures
Inspection ESP System Bleeding This procedure should be followed to ensure adequate bleeding of air and filling of the ESC unit, brake lines and master cylinder with brake fluid. 1. Remove the reservoir cap and fill the brake reservoir with brake fluid. ...