Hyundai Kona: Airbag Module / Curtain Airbag (CAB) Module Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the roof trim.
(Refer to Body - "Roof Trim Assembly")
3.
Remove the curtain airbag (B) after disconnecting the curtain airbag harness connector (A) and loosening the mounting bolts.

Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Tighten the curtain airbag mounting bolts and nuts.
Tightening torque :
Bolt : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
  
•
Never twist the airbag module during installation. If the airbag module is twisted, the airbag module may operate abnormally.
4.
Connect the curtain airbag connector.
5.
Install the roof trim.
(Refer to Body - "Roof Trim Assembly")
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Curtain Airbag (CAB) Module Description and operation
Description Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs. The SRSCM determines deploymen ...

Airbag Module Disposal Description and operation
Airbag Disposal When you scrap a vehicle equipped with an airbag, you must deploy it first. When you deploy an airbag, you need to have a skilled mechanic do the work. The used ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Front Wheel Speed Sensor Components and components location
Components 1. Front wheel speed sensor 2. Front wheel speed sensor connector ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Resetting the sunroof
The sunroof may need to be reset if the following conditions occur: - The battery is discharged or disconnected or the sunroof fuse has been replaced or disconnected - The sunroof control lever is not operating correctly To reset the sunroof, perform the following steps: 1. Place the ignition switc ...

© 2018-2026 www.hkona.com