Hyundai Kona: Starting System / Description and operation

The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable.

When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.

The solenoid plunger and clutch shift lever are activated, and the clutch pinion engages the ring gear.

The contacts close and the starter motor cranks.

In order to prevent damage caused by excessive rotation of the starter armature when the engine starts, the clutch pinion gear overruns.

Starting System

...

Troubleshooting

Troubleshooting Symptom Suspect Area Remedy Engine will not crank Battery charge low Charge or replace batt ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Turn signals and lane change signals
To signal a turn, push down on the lever for a left turn or up for a right turn in position (A). To signal a lane change, move the turn signal lever slightly and hold it in position (B).The lever will return to the OFF position when released or when the turn is completed. If an indicator stays o ...

Hyundai Kona (OS) 2018-2026 Service Manual: Brake Pad Repair procedures
Replacement Front Brake Pad 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque : ...