Hyundai Kona: Engine Control System / Electric WGT Control Actuator Specifications

Specification
[EWGA Position Sensor]
Position
Output Voltage [V]
Operating Angle [°]
Range of Rod [mm], reference
Mechanical Close end stop Position (MCP)
4.8
0
0
Electrical Close end stop Position (ECP)
4.2
12
1.8
Electrical Open end stop Position (EOP)
1
79
16
Mechanical Open end stop Position (MOP)
0.5
90
18

[EWGA DC Motor]
Item
Specification
Coil Resistance (Ω)
1.44 - 1.96 [21°C (69.8°F)]

Electric WGT Control Actuator Description and operation
Desrcription The Electric WGT Control Actuator is installed on the turbocharger. It operates the vain in the Waste Gate Turbocharger (WGT) and regulates the compressed air amount ...

Electric WGT Control Actuator Troubleshooting
Signal Waveform ...

Other information:

Hyundai Kona (OS) 2018-2025 Service Manual: Brake Pad Repair procedures
Replacement Front Brake Pad 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque : ...

Hyundai Kona (OS) 2018-2025 Service Manual: Crankshaft Position Sensor (CKPS) Repair procedures
Inspection 1. Check signal waveform of CKPS and CMPS using a GDS. Specification : Refer to "Waveform" Removal 1. Turn the ignition switch OFF and disconnect the battery negat ...

© 2018-2025 www.hkona.com