Hyundai Kona: Engine Control System / Electric WGT Control Actuator Description and operation

The Electric WGT Control Actuator is installed on the turbocharger. It operates the vain in the Waste Gate Turbocharger (WGT) and regulates the compressed air amount by the ECM's PWM signal. This actuator consists of a DC motor which actuates the vane, a 2-step gear which increases torque of the DC motor, a position sensor which detects status of the vane, an electric control unit which drives the DC motor.

CVVT Oil Control Valve (OCV) Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the OCV connector. 3. Measure resistance between the ...

Electric WGT Control Actuator Specifications

Specification [EWGA Position Sensor] Position Output Voltage [V] Operating Angle [°] Range of Rod [mm], reference ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Repair procedures
Inspection ESP System Bleeding This procedure should be followed to ensure adequate bleeding of air and filling of the ESC unit, brake lines and master cylinder with brake fluid. 1. Remove the reservoir cap and fill the brake reservoir with brake fluid. ...

Hyundai Kona (OS) 2018-2026 Service Manual: Idler Repair procedures
Removal and Installation 1. Remove the drive belt. (Refer to Timing System - "Dreve Belt") 2. Remove the idler (A). Tightening torque : 42.2 - 53.9 N.m (4.3 - 5.5 kgf.m, 31.1 - 39.8 ...